Steps | _While still in Continuous Monitor mode
from Step Y2, observe VOM or STAR LED for a fault indication while
performing the following:
_While looking for faults, grasp the harness close to the TFI connector. Wiggle, shake or bend a small section of the ignition and EEC-IV systems harness while working your way to the other components and dash panel. Also wiggle, shake or bend EEC-IV harness from the dash panel to the processor. Isolate the PIP circuit if needed for this test. |
Result | Is a fault indicated? |
Direction | YES
Isolate fault and service as necessary. Clear Continuous Memory Code 14. Refer to Appendix in Section 16. Rerun Quick Test NO GO to Continue |