y4: Check Processor and Harness Connectors
| Steps | _Key off, wait 10 seconds
_Disconnect processor 60 pin connector. Inspect for damaged pins, corrosion, loose wires, etc. Service as necessary. |
| Result | Are connectors and terminals OK?
Reconnect processor when this Step is completed. |
| Direction | YES
Unable to duplicate an erratic ignition fault in the EEC-IV System For further diagnosis, GO to Section 15, Ignition System Diagnostics. NO Service as necessary. Clear Continuous Memory Code 14. Refer to Appendix in Section 16. Rerun Quick Test. |