fd2: Cycle BOO Circuit
| Steps | _Key Off, wait 10 seconds
_Disconnect 60 pin connector. Inspect for damaged pins, corrosion, loose wires, etc. Service as necessary. _Breakout box installed _Processor connected _DVOM on 20 volt scale _Measure voltage between Test Pin 2 and Test Pin 40 at the breakout box while depressing and releasing brake |
| Result | Does the voltage cycle? |
| Direction | YES
Remove breakout box. Replace processor. Rerun Quick Test NO GO to Continue |
| Component | |
| Description | |
| Location | |
| Wire Colors | |