Steps | _MAP/BP tester connected
_Key On |
Result | (Only) Green light, VREF is OK. GO to Continue
"Less than 4V" light (RED) or no lights, VREF is too low. GO to Continue "Greater than 6V" light (RED), VREF is too high. |
Component | Barometric Absolute Pressure Sensor |
Description | The
BP sensor measures barometric pressure using a frequency. This gives
the EEC information on engine load. The BP is used as a barometric
pressure sensor for altitude compensation, updating the EEC during Key
On Engine Off and every wide-open throttle.
The EEC uses the BP information for: Spark advance EGR flow Air/Fuel ratio |
Location | Mounted behind Integrated Relay Controller; in front of passenger strut tower. |
Wire Colors | Orange with White stripe
Light Green with Black stripe Black with White stripe |
Notes | While the BP has a port typical of a MAP sensor, this port is NOT hooked to any vacuum source, and simply is a atmosphere vent. |