fd4: Check Continuity of BOO Circuit
| Steps | _Key Off
_Breakout box installed _Processor disconnected _DVOM on 200 ohm scale _Disconnect BOO circuit from 14290 harness (12 pin connector) _Measure resistance between Test Pin 2 at the breakout box and BOO circuit at the 14290 harness connector |
| Result | Is resistance greater than 5 ohms? |
| Direction | YES
Remove breakout box. Reconnect processor. Service open circuit. Rerun Engine Running Self-Test NO GO to Shop Manual Group 32 |
| Component | |
| Description | |
| Location | |
| Wire Colors | |