|Steps||_Key off, wait 10 seconds
_Disconnect processor 60 pin connector. Inspect for damaged pins, corrosion, loose wires, etc. Service as necessary.
_Install breakout box, leave processor disconnected
_DVOM on 20 volt scale
_Connect positive test lead to Test Pin 1 and negative test lead to Test Pin 40 or 60 at the breakout box.
|Result||Is voltage less than 10.5 volts?|
Service open circuit. Remove breakout box. Reconnect processor. Rerun Quick Test.
Remove breakout box. Replace processor. Rerun Quick Test.
|Notes||If on initial Key On Engine Off Self-Test, no voltage to the processor is observed, a Code 15 will be generated.|