n2: Check for Short to Ground
| Steps | _Key Off, wait 10 seconds
_Breakout box installed, processor disconnected _DVOM on 200,000 ohm scale _Measure resistance between Test Pin 4 and Test Pins 40, 46, and 60 at the breakout box |
| Result | Are all resistances above 10,000 ohms? |
| Direction | YES
Remove breakout box. Reconnect E-Core ignition coil and processor. GO to Continue NO Remove breakout box. Service short to ground in IDM circuit. Reconnect E-Core ignition coil and processor. Rerun Quick Test. |