ka8: Check Continuity of EGR Circuit
| Steps | _Key Off, wait 10 seconds
_EGR solenoid disconnected _Disconnect processor 60 pin connector. Inspect for damaged pins, corrosion, loose wires, etc. Service as necessary. _Install breakout box, leave processor disconnected _DVOM on 200 ohm scale _Measure resistance between Test Pin 35 (Test Pin 33 for 2.3L TC) at the breakout box and EGR circuit at vehicle harness connector |
| Result | Is resistance less than 5 ohms? |
| Direction | YES
GO to Continue NO Remove breakout box. Reconnect all components. Service open circuit. Rerun Quick Test |