ka10: Check for Short to Power
| Steps | _Key Off, wait 10 seconds
_DVOM on 200,000 ohm scale _Breakout box installed _Processor disconnected _EGR solenoid disconnected _Measure resistance between Test Pin 35 (Test Pin 33 for 2.3L TC) and Test Pins 37 and 57 at the breakout box. |
| Result | Is resistance greater than 10,000 ohms? |
| Direction | YES
Remove breakout box. Reconnect all components. Replace processor. Rerun Quick Test NO Remove breakout box. Reconnect all components. Service short to power. Rerun Quick Test. If code is repeated, replace processor |