Steps | _Still in Key On Engine Off Continuous Monitor Mode
_Observe VOM or STAR LED for a fault indication while performing the following: _Referring to the illustration, grasp the harness closest to the sensor connector. Wiggle, shake or bend a small section of the EEC-IV system harness while working your way to the dash panel. Also wiggle, shake or bend the EEC-IV harness from the dash panel to the processor. |
Result | Is a fault indicated? |
Direction | YES Isolate fault and service as necessary. Clear Continuous Memory Code 61. Refer to Appendix in Section 16. Rerun Quick Test. NO GO to Continue |
Component | Engine Coolant Temperature Sensor |
Description | The ECT sensor reports the engine coolant temperature to the EEC.
The ECT signal input is used by the EEC to: Modify ignition timing EGR flow Air to fuel ratio |
Location | Threaded into between Fuel Injectors 2 and 3 |
Wire Colors | Light Green with Yellow stripe
Black with White stripe |
Image | http://www.tbirdheritage.com/turbocoupe/articles/ |