db11: Check Continuity of ACT Signal and Signal Return
| Steps | _Key OFF, wait 10 seconds
_Harness disconnected from ACT sensor _Disconnect processor 60 pin connector. Inspect for damaged pins, corrosion, loose wires, etc. Service as necessary _Install breakout box, leave processor disconnected _DVOM on 200 ohm scale _Measure resistance between ACT SIGNAL, at the ACT vehicle harness connector, and Test Pin 25 at the breakout box _Measure resistance between SIGNAL RETURN, at the ACT vehicle harness connector, and Test Pin 46 at the breakout box |
| Result | Are both resistances less than 5 ohms? |
| Direction | YES
Replace processor. Remove breakout box. Reconnect processor and ACT sensor. Rerun Quick Test NO Service open circuit(s). Remove breakout box. Reconnect processor and ACT sensor. Rerun Quick Test |
| Component | Air Charge Temperature Sensor |
| Description | The ACT provides the EEC with mixture (air and fuel) temperature information. The ACT is used both as a density corrector to airflow calculation and to proportion the cold enrichment fuel flow. |
| Location | Threaded into the lower intake manifold. |
| Wire Colors | Black with White stripe
Pink with Black stripe |
| Image |  |